Miro Humidifier Assembly– Step 7. Outer-funner placement

NR07 Series Miro Humidifier Assembly (NR07G and NR07S) step 7:

To connect the power cable, plug in the cable into the Controller located directly next to the Mist-maker USB port. Make sure that the cable is fully inserted into the Controller. Do not tug on wire as it can result in damage to the product.

Below is a diagram highlighting the necessary steps needed to plug in the power cable into the Controller:Screen_Shot_2023-01-05_at_5.30.07_PM.png

Was this article helpful?
0 out of 0 found this helpful



Article is closed for comments.